Appendix B: Utility Mode 119
To set the C|24 name to the default:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“System.”
3 Press the encoder switch that corresponds to
“Unit Name. “
4 Press the encoder switch that corresponds to
“Default.”
5 Press the encoder switch that corresponds to
“Save.”
Resetting User Preferences
This page lets you reset C|24 Footswitch prefer-
ences, Talkback preferences and Clip Hold time
for the built-in mic/line/DI preamplifiers to
their default values.
To reset the C|24 user preferences:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“System.”
3 Hold the encoder switch that corresponds to
“Reset User Prefs.”
4 Do one of the following:
• To confirm the reset, press the encoder
switch that corresponds to “OK.”
– or –
• To cancel the reset, press the encoder
switch that corresponds to “Cancel.”
5 When you are finished, press the encoder
switch that corresponds to “Exit.”
Resetting Analog Signal Routing
This page lets you reset C|24 monitor and cue
source selections, and Monitor solo, phantom
power, Mic/Line and HPF settings to their de-
fault values.
To reset monitor signal routing:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“System.”
3 Hold the encoder switch that corresponds to
“Reset Analog Routes.”
4 Do one of the following:
• To confirm the reset, press the encoder
switch that corresponds to “OK.”
– or –
• To cancel the reset, press the encoder
switch that corresponds to “Cancel.”
5 When you are finished, press the encoder
switch that corresponds to “Exit.”
To Next Page
Loading...
