Chapter 8: Operating Views and Modes 73
Muting Sends in Sends Console View
To toggle the mute status of a track’s send:
1 In the Channel Bar, press the Sends switch
that corresponds to the name of Send position
you want to mute.
2 In the Switch Functions section, press the
Send Mute switch to assign control of Send
Mute to the encoder switches.
3 Press the channel’s encoder switch.
When the send is muted, the switch is lit and
the LCD display temporarily shows “Mute.”
When the send is not muted, the switch is un-
lit and the LCD display temporarily shows “No-
Mute.”
To toggle the mute status of all sends on a track:
1 Press the Insert/Send Bypass switch so that it is
lit.
2 Press the Send switch in the track’s channel
strip.
Setting the Pre-/Post-Fader Status of
Sends in Sends Console View
To toggle the pre-/post-fader status of a track’s
send:
1 In the Channel Bar, press the Sends switch
that corresponds to the name of the Send posi-
tion you want to change.
2 In the Switch Functions section, press the
Pre/Post switch to assign control of pre-/post-
fader status to the encoder switches.
3 Press the channel’s encoder switch.
When the send is pre-fader, the switch is lit
and the LCD display temporarily shows “Pre.”
When the send is post-fader, the switch is un-
lit and the LCD display temporarily shows
“Post.”
To exit Send Console view:
Press the lit Sends switch in the Channel Bar.
– or –
Enter another view.
Channel Views
C|24 Channel views let you focus all of a track’s
pan controls, send controls, or inserts in the
C|24 LCD displays.
Pan/Send Channel View
In Pan/Send Channel view, Pan and Send con-
trols on the focused channel are displayed hori-
zontally across the LCD displays.
A track is focused in this view by pressing the
Send switch in its channel strip.
To display the Sends on a track:
1 Press the Send switch in the track’s channel
strip. The switch flashes to indicate track focus.
2 If necessary, do one of the following:
• To display Sends A-E, press the F-J switch so
that it is unlit.
– or –
• To display Sends F-J, press the F-J switch so
that it is lit.
The left side of the LCD display shows the
track name in the top row and “Pan/Send” in
the bottom row, followed by “Main Pan” in the
top row and the channel pan value in the bot-
tom row.
To Next Page
Loading...
Need help?
General
