Chapter 9: Working with C|24 101
Auditioning Start and End Points
of Selections
In Audition mode, you can listen to either the
start or end of a selection, with or without pre-
roll or post-roll.
To play audio starting at the pre-roll point up to the
start of a selection:
1 Press the Audition switch so that it is lit.
2 Press the Pre-Roll switch.
To play audio starting at the selection start
through the length of the post-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Mark In switch.
To play audio back-timed from the selection end by
the pre-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Mark Out switch.
To play audio starting at the end of a selection
through the post-roll amount:
1 Press the Audition switch so that it is lit.
2 Press the Post-Roll switch.
Editing
Selecting Edit Tools
You can select Edit tools by pressing the corre-
sponding switches in the Tools & Functions sec-
tion of C|24: Trim, Select, Grabber, Pencil, Smart
Tool. The following Edit tool functions are also
available:
To cycle through available versions of an Edit tool:
Press the corresponding Edit tool switch to cy-
cle through the versions of the tool.
To select the Smart Tool:
Press the Smart switch.
– or –
Press any combination of the Trim, Select,
and Grabber switches.
To lock and unlock Shuffle mode:
While in any Edit mode other than Shuffle
mode, hold the Command/Ctrl Modifier switch
and press the Shuffle switch.
Cutting and Pasting
To copy the current edit selection:
Press the Copy switch.
To paste a copied edit selection:
Press the Paste switch.
To Next Page
Loading...
