C|24 Guide16
If you have more than one Ethernet device in
addition to C|24:
1 Connect one end of a standard Ethernet cable
(not included) to the Ethernet port on the back
panel of C|24.
2 Connect the other end of the Ethernet cable
to a powered Ethernet hub (do not use any port
labeled for LAN connection).
3 Connect the Ethernet hub to the appropriate
Ethernet port on the computer.
Starting Up and Shutting
Down a Pro Tools System
Your C|24-based Pro Tools system should be
started up and shut down in a specific order.
Start your system in this order:
1 Turn on external hard drives first. Wait 10 to
15 seconds for them to come up to speed.
2 Turn on the C|24.
3 If you plan to work with MIDI equipment,
turn on MIDI interfaces and other MIDI devices.
4 Turn on all Pro Tools audio interfaces.
5 Turn on the computer.
6 Turn on monitor amplifiers or self-powered
speakers.
Shut down your system in this order:
1 Turn off monitor amplifiers or self-powered
speakers.
2 Turn off all Pro Tools audio interfaces.
3 Shut down the computer.
4 If you are using MIDI equipment, turn off
MIDI interfaces and other MIDI devices.
5 Turn off the C|24.
6 Turn off external hard drives.
Configuring C|24
All C|24 software is included when Pro Tools
software is installed. The Pro Tools installer
places the C|24 Personality file in the Control-
lers folder inside the Pro Tools folder.
Refer to the Getting Started Guide that came with
your system for instructions on installing or up-
dating Pro Tools software.
Updating System Firmware
Each release of Pro Tools software includes cur-
rent C|24 firmware. When you declare a C|24
unit in the Pro Tools Peripherals dialog,
Pro Tools prompts you if a firmware update is
available.
If you are prompted to update firmware, follow
the on-screen instructions to load the latest
firmware to the C|24.
To Next Page
Loading...
Need help?
General
