C|24 Guide18
Using Additional Control Surfaces
with C|24
When a C|24 is declared in Pro Tools, the use of
additional control surfaces is subject to the fol-
lowing restrictions:
You can use a MIDI-based control surface
(such as a Digidesign Command|8) or another
MIDI-based controller (such as the Digidesign
Surround Panner Option) at the same time as a
C|24. A MIDI control surface will mirror the first
8 channels on C|24.
You cannot use another Ethernet-based con-
trol surface (such as an ICON worksurface, Con-
trol|24, or ProControl) at the same time as a
C|24.
You cannot declare more than one C|24 on a
Pro Tools system at a time.
Setting C|24 Preferences
The following operational preferences for C|24
are set from the unit, not from Pro Tools.
External Talkback Microphone
You can choose to use an external Talkback mi-
crophone instead of the built-in Talkback micro-
phone in the C|24 Meter Bridge. See “External
Talkback Microphone” on page 116.
Talkback Latching
You can set Talkback to latch on when the Talk-
back switch is double-pressed. See “Talkback
Latching” on page 116.
Auto Talkback
You can enable Auto Talkback, which automati-
cally turns on the Talkback and Listen micro-
phones when the Pro Tools Transport is
stopped. See “Auto Talkback” on page 120.
Mic Pre Clip Hold Time
You can set the Clip Hold time for the C|24
built-in mic/line/DI preamplifiers. See “Mic Pre
Clip Hold” on page 117.
Footswitch Function
You can set the function and polarity for the
two Footswitch connectors on C|24. See “Foot-
switch Function and Polarity” on page 117.
Console Preferences
You can set the behavior of C|24 displays and
controls and how they interact with Pro Tools.
See “Console Preferences” on page 47.
To Next Page
Loading...
Need help?
General
