DigiDesign C24 - Page 125

Appendix B: Utility Mode 117
Mic Pre Clip Hold
You can set the Clip Hold time for the C|24
built-in mic/line/DI preamplifiers.
To set the Clip Hold time:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“Preferences.”
3 Press the encoder switch that corresponds to
“Analog.”
4 Press the encoder switch that corresponds to
one of the following:
•No Hold
•3 Sec Hold
• Infinite Hold
5 When you are finished, press the encoder
switch that corresponds to “Save.”
6 Press the Exit switch to exit Utility mode.
Footswitch Function and Polarity
You can set the function and polarity for the
two Footswitch connectors on C|24.
To set Footswitch function:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“Preferences.”
3 Press the encoder switch that corresponds to
“Footswitch.”
4 For each Footswitch (A and B), press the en-
coder switch that corresponds to any of the
following:
• Play: Starts and stops the Pro Tools Trans-
port.
• Record: Arms the Transport for recording
or punches in and out of Record.
• Talkback: Toggles Talkback On and Off.
5 When you are finished, press the encoder
switch that corresponds to “Save.”
6 Press the Exit switch to exit Utility mode.
To set Footswitch polarity:
1 Press the Utility switch.
2 Press the encoder switch that corresponds to
“Preferences.”
3 Press the encoder switch that corresponds to
“Footswitch.”
4 Press the encoder switch under “FS A Polarity”
(Footswitch A) or “FS B Polarity” (Footswitch B)
to toggle polarity between “Normal” and “In-
verted.”
5 When you are finished, press the encoder
switch that corresponds to “Save.”
6 Press the Exit switch to exit Utility mode.