C|24 Guide4
System Requirements
C|24 requires the following system components:
• A Digidesign-qualified Pro Tools system
• An available Ethernet connection on the
host computer
For complete system requirements, visit the
Digidesign website (www.digidesign.com).
Compatibility Information
Digidesign can only assure compatibility and
provide support for hardware and software it has
tested and approved.
For a list of Digidesign-qualified computers, op-
erating systems, and third-party devices, visit
the Digidesign website (www.digidesign.com).
Operational Requirements
Temperature and Ventilation
C|24 should be installed and operated in a cli-
mate-controlled environment, away from heat
sources, and with adequate ventilation.
C|24 should be operated at an ambient temper-
ature that does not exceed 100 degrees F
(35 degrees C).
The back panel of the C|24 should be exposed to
ambient air. Blocking or partially blocking the
back panel of the C|24 may cause the unit to
malfunction and may void your warranty.
Water and Moisture
C|24 should be operated away from sources of
moisture or humidity and should be kept clear
of liquids that might spill into the unit.
Cleaning and Maintenance
If you need to clean the C|24 top surface, apply
a small amount of water to a cloth or paper
towel, then carefully wipe the surface.
Do not use abrasives, cleaning solutions, or
spray cleaners.
To Next Page
Loading...
Need help?
General
