DigiDesign C24 - Page 122

C|24 Guide114
Internal
The Internal test verifies the first stage of Ether-
net communication by sending data packets
through the unit’s Ethernet link chip.
To perform the Internal Ethernet test:
 From the Ethernet Test page, press the en-
coder switch that corresponds to “Internal.”
To restart the “Sent” and “Received” packet
counts:
 Press the encoder switch that corresponds to
“Restart Counts.”
To exit the Internal Ethernet test:
 Press the encoder switch that corresponds to
“Exit.”
External
The External test verifies the second stage of
Ethernet communication by sending data pack-
ets out of the C|24 Ethernet port and back into
the unit using an Ethernet loopback connector
(included with C|24).
To perform the External Ethernet test:
1 If Pro Tools is running, quit Pro Tools.
2 Disconnect C|24 from the Ethernet network.
3 Plug the Ethernet Loopback connector into
the C|24 Ethernet port.
4 From the Ethernet Test page, press the en-
coder switch that corresponds to “External.
To restart the “Sent” and “Received” packet
counts:
 Press the encoder switch that corresponds to
“Restart Counts.”
To exit the External Ethernet test:
 Press the encoder switch that corresponds to
“Exit.”
LED Test Page
The LED tests let you test all red, yellow, or
green LEDs on C|24 individually.
To test the LEDs:
 From the LED Test page, press the encoder
switch that corresponds to any of the following
to test all LEDs of the specified color:
•Red LEDs
• Yellow LEDs
• Green LEDs
To exit an LED test:
 Press the encoder switch that corresponds to
“Exit.”
Vegas Mode
Vegas mode randomly lights every switch,
meter, and display on the unit, and runs the fad-
ers in a sine wave pattern.
To enter Vegas mode:
 Press the encoder switch that corresponds to
“Vegas Mode.”
To vary the rate of LED blinking and fader motion:
 Turn the Scrub/Shuttle wheel or any rotary
encoder.
To exit Vegas mode:
 Press any switch on the unit.