Chapter 4: Digi 002 Top Panel 39
Pan/Send When you press the Pan/Send switch,
Digi 002 identifies channels with sends assigned
to them by illuminating their Channel Select
switches. If no sends are present, no Channel Se-
lect switches will be lit.
When you press an illuminated Channel Select
switch, Channel Scribble Strip 1 and the first ro-
tary encoder show track pan position for that
track. (If the track is a stereo track, you can tog-
gle between left and right pan by pressing the
Encoder Mode switch immediately to the right
of the encoders.)
Channel Scribble Strips 3–7 show the names and
their rotary encoders control the levels for all
five sends on that track. (Channel Scribble Strip
2 is inactive.) In this mode, the Channel Select
switches on channels 3–7 toggle pre- and
post-fader metering for the corresponding send.
Plug-In Page Switches Plug-In controls are orga-
nized in pages. In a process much like banking of
channel faders, when a plug-in has more con-
trols than can fit on the Channel Scribble Strips
at one time, you can use these switches to page
through the plug-in controls.
When a plug-in has multiple pages of controls,
one of the Plug-In Page switches will flash to in-
dicate a next or previous page. The total number
of pages is shown in the Status Display when
you press the flashing Plug-In Page switch.
Multi-Mono Plug-ins
When working with a multi-mono plug-in, you
can toggle the view between the left and right
sides of the plug-in by holding down the Dis-
play switch when you press the Channel Select
switch to select a plug-in from Channel view.
The resulting display shows “left” and “right” in
the Scribble Strips, allowing you to choose be-
tween the two sides of the multi-mono plug-in
by pressing the corresponding Channel Select
switch.
Plug-In Master Bypass Switch This switch by-
passes either a single plug-in or all plug-ins on a
channel, depending on the current view. If the
controls for only one plug-in are displayed, only
that plug-in will be bypassed. If all the plug-ins
on a channel are displayed, all of those plug-ins
will be bypassed.
If no plug-ins are displayed, the Master Bypass
function is unavailable.
Esc (Escape/Cancel) Switch When flashing,
this switch allows you to cancel certain opera-
tions on the Digi 002, such as Channel View se-
lections. The Escape/Cancel switch also func-
tions as a “cancel” button for many on-screen
dialogs in Pro Tools.
Hardware I/O inserts cannot be bypassed in
Pro Tools, so the Plug-In Master Bypass
switch has no effect on them.
To Next Page
Loading...
Need help?
General
