Digital Projection 7000 Series User Manual

Digital Projection E-Vision 7000 Series Operating The Projector Installation and Quick-Start Guide
11
Rev B May 2013
Switching the projector off
• Press on the control panel or STANDBY on the remote control, then press the button a second time within 5 seconds to conrm your
intention to switch off.
The lamp will go off, and the Power indicator on the control panel will ash amber for a few seconds whilst the lamp cools. The Power
indicator on the control panel will then show amber and the projector will be in Standby mode.
• Switch off at the switch next to the power connector. Disconnect the power cable from the projector.
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector

Digital Projection 7000 Series Specifications

General

Brand	Digital Projection
Model	7000 Series
Category	Projector
Language	English