Advance Setting submenu
Security Lock
• When the Security Lock is enabled, a security Password will need to entered before the
projector can be used, or before the lock can be Disabled.
• When setting the lock for the rst time, the Password will need to be entered twice, to
ensure that it has been entered correctly.
Keypad Lock
• To lock the control panel keys, use or to move the green highlight to YES or
NO, then press ENTER to conrm your selection.
• To unlock the keys, press and hold for 5 seconds.
Image Capture
• To capture the current screen image for use as the Custom background, use Save Image. This will take approximately 2 minutes.
• To delete the currently saved image, use Delete.
Wall Color
• Set this to suit the projection screen.
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Setup Menu
Advance Setting Submenu
The Password is made of a
combinationofvepressesonthe
, , and keys.
Image Capture is available only:
- for Component, Computer 1,
Computer 2 and Computer 3 inputs;
- when Aspect Ratio is set to
Normal;
- for native resolution images:
(1280x800 for E-Vision WXGA,
1024x768 for E-Vision XGA)
There are two storage locations: one
for the 4 segment color wheel and
one for 6 segment color wheel.
If you change wheels you will need
to recapture the image. If you
changeback,theimagefortherst
wheel will still be in memory.
MENU = END | SEL/ADJ. | SEL.
SetupVideo
Installation
SignalPicture
Security Lock
Keypad Lock
Image Capture
Wall Color
Messaging
Advance Setting
Off
On
Disable
Setup menu continued
To Next Page
Loading...
Need help?
General
