Background
• Set this to determine what appears on screen when the projector is searching for a valid
input source.
Audio
• Use the Audio Submenu to turn the speakers On and Off, and set the Volume.
3D Mode
• Use the 3D Mode Submenu to turn the DLPLink synchronisation signal On and Off, and
to invert the signal if necessary.
Aspect Ratio
• Select from Normal, Full, 4:3, 16:9, and Native, as follows:
• Normal: the image will be displayed at its intended aspect ratio, lling either the full
height or width of the screen as appropriate.
• Full: the image will ll the height and width of the screen, depending on the
resolution of the projector.
• 4:3: the image will be displayed with a 4:3 aspect ratio, tting the full height and/or
width of the screen, depending on the resolution of the projector.
• 16:9: the image will be displayed with a 16:9 aspect ratio, tting the full height and/or
width of the screen, depending on the resolution of the projector.
• Native: the image will be displayed pixel for pixel with no scaling. This could be
smaller than full screen or cropped to full screen, depending on the resolutions of the
image and projector.
Notes
To set a background image to
be displayed when Custom is
chosen, see the Advanced Setting
Submenu on the next page.
The full height and width of the
screen will depend on the projector
model. For more information, see
the Specication leaet, or the
Important Information.
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Setup menu continued
To Next Page
Loading...
Need help?
General
