Signal menu
Horizontal and Vertical Position, Phase, Clock
• Adjust the sliders for these settings, as required.
Reset
• Press ENTER to restore the four settings above their factory defaults.
• When the warning message appears, use or to move the green highlight to
YES or NO, then press ENTER to conrm your selection.
Resolution
• Set this to Auto, unless the projector has problems selecting between Wide and 4:3 with
some signals on the Computer 1, Computer 2 and Component inputs.
Auto Sync
• Set this to On if you want the projector to automatically synchronise with the input signal.
• Set this to Off if the settings are to be made manually, using the sliders above only.
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
These settings are used for VGA
signals only.
Do NOT do this unless you are
sure that you want to restore the
settings to their factory defaults.
The Resolution setting is needed
only for VESA 1024x768_ 60,
VESA 1280x768_60,
VESA 1400x1050_60 and
VESA 1680x1050_60 signals on
the Computer 1, Computer 2 and
Component inputs.
The Auto Sync setting is used for
VGA signals only.
To Next Page
Loading...
Need help?
General
