Setup menu
Auto Search
• When this is set to On, the projector will search for an alternative input source when the
current input source is disconnected
• When this is set to Off, the projector will show the ‘background’ screen when the current
input source is disconnected.
Auto Power Off
• Set this to On, if you want the projector to go into Standby mode when no input source
is detected for 20 minutes.
Auto Power On
• Set this to On, if you want the projector to start up immediately when the mains is
connected.
• Set this to Off, if you want the projector to go into Standby mode when the mains is
connected. In this case, the projector will not start up until the POWER button is pressed
on the control panel or the remote control.
Standby Mode
• Set this to Standard or Eco as required.
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
To set the background screen, see
the next page.
When Standby Mode is set to Eco:
the Monitor Out signal is disabled,
and the RS232 connection is
disabled, so it will not be possible
to turn the projector On remotely,
except via the LAN connection.
To Next Page
Loading...
Need help?
General
