TECHNICAL REFERENCE MANUAL
Precautions:
Only use this product as a measuring sensor, not as a control device. The system must be configured and operated in such a way that no
damage will occur in the event of an erroneous measurement, malfunction of the device or power failure due to installed safety measures
(e.g. safety limit switch).
WARNING:
Operate the equipment appropriately in accordance with the regulations in force. Always prevent access to the
equipment by unauthorized personnel.
Precautions:
Do not point the telescope directly at the sun.
CAUTION:
Be careful when pointing a telescope towards the sun, because the telescope functions as a magnifying glass and
can injure eyes and/or cause damage inside the DLS-C(H)/FLS-C(H).
10.5 Laser classification
The DLS-C(H)/FLS-C(H) produces a visible laser beam, which emerges from the front of the instrument.
It is a Class 2 laser product in accordance with:
- IEC60825-1 (2007) ”Radiation safety of laser products”
- EN60825-1 (2007) ”Radiation safety of laser products”
It is a Class II laser product in accordance with:
- FDA 21CFR 1040.10 and 1040.11 (US Department of Health and Human Service, Code of Federal Regulations)
Laser Class 2/II products:
Do not stare into the laser beam or direct it towards other people unnecessarily. Eye protection is normally afforded by aversion responses
including the blink reflex.
WARNING:
Looking directly into the beam with optical aids (binoculars, telescopes) can be hazardous.
Precautions:
Do not look into the laser beam. Make sure the laser is aimed above or below eye level. (particularly with fixed installations, in machines,
etc.).
CAUTION:
Looking into the laser beam may be hazardous to the eyes.
Distance Laser Sensor Page 50/53
To Next Page
Loading...
Need help?
General