Dini Argeo DGT4X Technical Manual

37
Optimized layout for A4 print.
TYPE
A
888888
Setup
C
ConfiG param stabil
auto.0
0.traCk
0-perC
1 1 1
2
4
3
C.perC
C.perC
disab
enab
CyCle
1
1
1
2
3
tr 10
tr 8
tr 6
tr 4
tr 2
tr 1
tr1/2
tr1/4
TR no
1
2
3
4
5
6
7
8
9
i
auto.0
2
0-perc
3
0-perc
4
TECH_MAN_ENG_DGT4X
LEGEND:
Indicates repeated pressing of
the key.
Parameter visible only
under certain conditions.
Parameter or menu subject
to approval.
Default value of the parameter.
Reset functions and parameters
Indicates the weight value that can be zeroed by key or command.
The value is expressed as % of the full scale. For example: if the scale has a full scale
(RANGE1) of 1000 kg, by setting 3% it is possible to zero up to 30 kg.
The value 0 disables the ZERO key and the zeroing commands.
Disabled.
% auto-zeroing on start-up.
% manual zeroing.
Zero tracking.
Enabled, enter in C.PERC the % value of the capacity.
In Ind.Ch mode, it is possible to perform an auto-zeroing
cycle of all connected scales. Enter in C.perC the % value
of the capacity.
Maximum percentage of manual zeroing
Auto-zeroing on start-up
from 0 to 50%.
from 0 to 10%.
from 0 to 50%.
from 0 to 2%.
= 2%.
10 divisions.
8 divisions.
6 divisions.
4 divisions.
2 divisions.
1 division.
1/2 division.
1/4 division.
Tracking disabled.
This menu allows to set zero tracking, i.e. the compensation parameter of the thermal drift of the scale; the set value corresponds to
the number of divisions that is reset to zero in the fixed time of 1 second.
Zero tracking
In the case of an approved transmitter, it is possible to select the values tr1/2, tr1/4, tr no.
Visible only if
type ≠ ind.Ch

Dini Argeo DGT4X Specifications

General

Brand	Dini Argeo
Model	DGT4X
Category	Transmitter
Language	English