42
Optimized layout for A4 print.
888888
Type
A
888888
F.mode
C
funCt viss
1 1
peak
alibi
Conver
none
2
4
3
5
viss
peak
conver
alibi
none
TECH_MAN_ENG_DGT4X
MENU ACCESS:
SAVING THE PARAMETERS:
Press the key during the start-
up procedure.
Press the key several times, until the display shows
SAVE?. Press the key to confirm.
Complete menu
on pages 24 - 25
Use functions
Converting units of measurement
Peak detection
High resolution
Alibi memory
No function
Weight display in high resolution (x10). Press the key to activate or deactivate the function.
When the weight is displayed in high resolution, the
F
light is lit.
In the case of an approved transmitter, the high-resolution weight display is automatically deactivated after 5 seconds.
Detection of the maximum weight value during a time interval. Press the key to activate the function. The display shows
“-peak-” every 5 sec and the transmitter shows the maximum weight reached since the function was activated.
To deactivate the function press the again, the display shows “peakof” for a moment and shows the instantaneous
weight again.
By holding down the key it is possible to select in the piC.tim parameter the minimum time of the pulse duration,
expressed in hundredths of a second. The lower this value, the higher the peak function sensitivity.
Converting the scale unit of measurement using a free conversion factor. Press the key to convert the weight to
pounds. By holding down the key, you can enter a free conversion factor, which will be multiplied by the weight.
Example: to make the display show the cubic meters of water on the scale, enter the value 997 as the conversion factor.
The key can be used to switch from the main unit of measurement to the secondary unit at any time.
When the secondary unit of measurement is displayed, the
F
light is lit.
(See section “Alibi memory” page 42).
No function when the key is pressed.
To Next Page
Loading...
Need help?
General
