Dini Argeo DGT4X Technical Manual

38
Optimized layout for A4 print.
888888
DISAB
loCk
ENAB
unloCK
Disab
Type
Type
A
A
888888
888888
F.mode
F.mode
C
C
funCt
funCt
1
1
rs.zero
tare
5
5
TECH_MAN_ENG_DGT4X
MENU ACCESS:
SAVING THE PARAMETERS:
Press the key during the start-
up procedure.
Press the key several times, until the display shows
SAVE?. Press the key to confirm.
Complete menu
on pages 24 - 25
By pressing the key, or sending the zero command, the transmitter zeroes the gross weight on the scale. For a moment the display
shows “zero” and then it shows 0 (gross weight).
The semi-automatic zeroing cannot be performed if:
• The weight on the scale is greater than the zero capacity (0.perC).
• The weight is unstable.
Restoring zero
Semi-automatic zeroing
Zero restoring disabled.
Zero restoring enabled.
 If auto.0 = disab:
The last zero in the memory before turning o the power is always
restored.
 If auto.0 = enab / CyCle:
The last zero in the memory before turning o the power is restored
only if the auto-zeroing fails.
Tare functions and parameters
Tare blocked. When the gross weight drops to 0, the tare remains
engaged.
Tare unlocked. When the gross weight drops to 0, the tare is cleared.
Tare disabled.
Tare mode
Semi-automatic tare
By pressing the key, or sending the tare command, the transmitter sets as tare the weight on the scale. For a moment the display shows
“tare” and then it shows 0 (net weight). The NET light indicates that the net weight is shown on the display.
The semi-automatic tare cannot be performed if:
• The weight is less than one division.
• The weight is overloaded.

Dini Argeo DGT4X Specifications

General

Brand	Dini Argeo
Model	DGT4X
Category	Transmitter
Language	English