DINO 210XT
25
6. Start the engine with button 2 (green)
The electric timer of the lift automatically disconnects the supply voltage (12 VDC) 1 hour after the
last time the electric or combustion engines were in operation.
Re-activate the power supply by pressing the start button either on the chassis control panel or on
the platform control panel.
Petrol engine:
- turn off the choke
- adjust the engine speed
7. Lower the front support outriggers (on the tow-bar side)
8. Lower the rear support outriggers (do not damage the tow-bar jockey wheel)
9. Level the chassis with the outriggers with the help of the level gauge (16) (Fig. C). The air
bubble must be located inside the inner ring.
MAKE SURE THAT THE WHEELS ARE CLEARLY OFF THE GROUND (FIG. D)
- the (green) signal light 4A on the chassis control panel comes on when all outriggers are in the
lower position and the outrigger limit switch circuit is connected
- make sure all outriggers are firmly supported on the ground
To Next Page
Loading...