DINO 210XT
43
SERVICE AND INSPECTION INSTRUCTIONS
1. The first service after 20 hours of operation
- change the pressure filter element
- adjust the brakes according to the instructions on page 47
- check the the wheel bolts for tightness after about 100 km of driving (325 Nm)
2. Daily service
- check the oil level in the hydraulics, top up if necessary
- check the hydraulic connections
- check the unit visually
- check the operation of the emergency descent and emergency stop functions
- check the operation of the safety devices
3. Weekly service
- check the tyre pressure (450 kPa, jockey wheel 250 kPa)
- grease the fulcrum pins (refer to lubrication plan, page 43)
- check the sliding surfaces of the telescope and apply silicon if necessary
- check the clearance between the slide pads and surfaces and adjust the pads if necessary
- put a load of about 80 kg onto the platform and drive the boom to level position
Continue by extending the telescope until the red signal light lights up and the movement
stops. Measure the stroke in accordance with the instructions on page 58 and compare it
with the setting of the outreach limit RK4. If the stroke exceeds the allowed value, contact
the service person.
4. Service every six months
- change the hydraulic oil and the filter cartridge.
- check the condition of the brakes
- check the the wheel bolts for tightness (325 Nm)
- grease the gear ring of the turning device
5. Periodic service every 12 months ín accordance with the instructions for regular
servicing below in this manual
IF THE LIFT IS OPERATED UNDER DEMANDING CONDITIONS (IN
EXCEPTIONALLY HUMID OR DUSTY ENVIRONMENT, CORROSIVE CLIMATE,
ETC.) THE INTERVALS BETWEEN THE OIL CHANGES AND THE OTHER
INSPECTIONS SHALL BE SHORTENED TO MEET THE PREVAILING CONDITIONS
IN ORDER TO MAINTAIN THE OPERATIONAL SAFETY AND RELIABILITY OF THE
LIFT.
THE PERFORMANCE OF THE PERIODIC SERVICING AND THE INSPECTIONS IS
ABSOLUTELY MANDATORY, BECAUSE THEIR NEGLIGENCE MAY IMPAIR THE
OPERATIONAL SAFETY OF THE LIFT.
THE GUARANTEE WILL NOT REMAIN VALID, IF THE SERVICING AND THE
PERIODIC INSPECTIONS ARE NOT PERFORMED.