DINO 210XT
87
CHASSIS CONTROL CENTRE (LCB), OTHER ITEMS
F1: 1.6A FUSE FOR TIMER CARD ACTIVATION CIRCUIT
F2: 10 A CONTROL FUSE FOR START CIRCUIT AND OUTREACH MONITORING
CIRCUIT
F3: 10 A CONTROL FUSE FOR DRIVING DEVICE
F4: 5 A FUSE FOR CONTROL LEVERS AND JOYSTICK ON THE CHASSIS AND
PLATFORM CONTROL PANELS
F5: 1,6 A CONTROL FUSE FOR DRIVING DEVICE
F6: FUSE FOR SOLENOID VALVES 10A
F7: 10 A CONTROL FUSE FOR EMERGENCY DESCENT CIRCUIT
F8: 10 A FUSE FOR CONTROL OF COMBUSTION ENGINE
F12: TIMER CARD FUSE 16A
H3: YELLOW LED SIGNAL LIGHT
Indicates the operation of the outrigger limit switches RK11-RK14.
H4: RED LED SIGNAL LIGHT
Indicates the tripping of the SR3.
HM1: HOUR METER
Measures the running hours of the machine.
Q1: TURN SWITCH WITH KEY
Selector switch for choice of operating location.
1 = Chassis
2 = platform
3 = chassis panel
T1: POWER SUPPLY
Feeds the 12 VDC control voltage to the system as the machine is being powered by AC-
supply.
TC: TIMER CARD
Control card for supply voltage.
Connects the control voltage supply from the power source while the AC feed is connected.
Switches over the voltage supply feed from battery.
Disconnects the supply voltage from the lift after a preset delay (normally 1 hour)
Start buttons S2 and S6 are used for re-activation of the control voltage.
TR9: RESISTOR
Adjustable resistor for movement speed for operation from the chassis panel.
TR10: RESISTOR
Adjustable resistor for lowering speed of platform levelling.
To Next Page
Loading...