DINO 210XT
72
- check the condition of the chassis
- general condition
- check the attachment of the tow-bar to the chassis
- check the condition of the overrun and its attachment to the chassis.
- check the axle and its attachment to the chassis
- check the attachment and condition of the brake wires and rods
- check the rims, the tightness of the wheel bolts, the tyres and the tyre pressure
- check the condition of the driving device, attachment of the parts and condition of
the covers for electric components
- check the condition of the transport support of the boom
- perform a test run, test all operating controls, control the outreach with a load of 215 kg on the
platform according to the instructions on page 58
- also check the operation of the limit switches during the test run (refer to the service
instructions)
- the load-sensing limit switches on the safety devices
- the limit switches on the outriggers, which prevent the operation of the boom
movements
- the limit switches on the tow-bar, which prevent the use of the outriggers
- after the test-loading make sure that the test loading has not caused any defects, such as
fractures or permanent deformations of dangerous nature, on the steel structures or other loaded
parts
- draw up a protocol of the regular inspection with following articles:
1. inspection form
2. data of repair welds
a) date of repair
b) repaired by whom
c) what was repaired
- as the machine is ready for operation after the annual inspection, mark the inspection date on the
inspection plate affixed to the lift
EXTRAORDINARY INSPECTION
(INSPECTION AFTER AN EXCEPTIONAL SITUATION)
The inspection is required if the lift has been damaged in a manner which may affect its load-
bearing capacity or safe operation.
- in this case the lift shall be inspected according to the instructions for the annual inspection
- the lift shall be subjected to a test loading and a stability test
- a protocol shall be drawn up for the inspection
To Next Page
Loading...