DINO 210XT
52
REGULAR SERVICING
The lift shall be serviced regularly at intervals of 11 - 12 month.
Under demanding conditions where moist, corrosive substances or corrosive climate may speed up
the deterioration of the structure and induce malfunctions, the inspection must be performed more
often and the influence of corrosion and malfunctions must be reduced by using appropriate
protective means.
Only technical specialists who are familiar with the structure and the operation of the lift are
allowed to maintain the lift.
We recommend turning to the service staff of the dealer.
SCHEDULE FOR REGULAR SERVICING
1. Clean the lift thoroughly before the service
The hydraulic and electric appliances must not be dismantled if they are not clean. Any
contaminants in the system may cause malfunctions later on. Wash the lift externally.
ATTENTION!
Be careful not to direct the high pressure water jet straight to the electric appliances, such as the
control panels on the chassis and on the platform, relays, solenoid valves and limit switches.
- use pressure air to dry the electric devices, hydraulic connectors etc.before opening them
- apply appropriate moisture repellent to the electric appliances after the drying
- always protect the piston rods with e.g. CRC3-36 anti-corrosive agent after washing with a
solvent
REMEMBER CLEANLINESS!
To Next Page
Loading...