Dino 210XT - Driving Device Controls and Precautions; Driving Control Execution; Post-Drive Procedures

DINO 210XT
37
- release the parking brake
- drive the unit using the pushbuttons
forward / backward 28A
to the left 28A + 28L
to the right 28A + 28R
- do not drive the jockey wheel into obstacles or potholes
ATTENTION! If one of the wheels bumps into an obstacle, the lift may turn abruptly.
- after the driving apply the parking brake
- disconnect the driving device from the wheel
- Switch on the driving device by turning the switch 27 to position 0
Remote control of the driving device (optional extra).
- plug in the remote control cable to the socket in the driving device control box
ATTENTION!
Be careful not to damage the jockey wheel tube by extending it too much.
As the lift is moved with the driving device, the suitable length for the jockey wheel stem can be
achieved by adjusting the gap between the lower surface of the tow-bar/brake rod and the wheel to
1 - 3 cm. Thus the wheel can turn freely.