DINO 210XT
45
EVERY 50 HOURS
1. Bearings of the safety device
2. Bearings of the outrigger cylinders
3. Bearings of the outriggers
4. Bearings of the outrigger foot plates
5. Bearings of the boom and the articulated arms
6. Bearings of the platform
7. Bearings of the levelling cylinders (except the bearing on the rod side of the upper levelling
cylinder)
8. Bearings of the lifting cylinder
9. Sliding surfaces/rolls of the telescope
10. Jockey wheel slide and threads
TWICE A YEAR
11. Bearing of the telescope cylinder
12. Driving device
13. Overrun brake - overrun
14. Turning device bearings* and gear ring
15. Bearing on the rod side of the upper levelling cylinder
Lubricant Esso Beacon EP2 or equivalent
The overload protection device joint (point 1) must absolutely be lubricated regularly and always
immediately after the lift has been washed.
Moving parts of the mechanism of the outrigger limit switch system must be lubricated every 50
hours.
If necessary, apply a thin grease film on moving parts of the ball-coupling.
Always lubricate the lift and apply a protective grease film immediately after the washing.
*Remove the crescent-shaped covers from the underside of the lift in order to enable lubrication of
the turning bearing nipples (4 pieces).
Lubricate the visible parts of the Flyer-chains for the boom twice a year. Use Master chain lubricant
1-4014 or equivalent.
To Next Page
Loading...