DINO 210XT
65
13. Warning signs and adhesives
- make sure that all warning signs and adhesives are legible, replace if necessary
14. Inspect the brakes and the driving device
- remove the wheels
- clean the brake system and check the settings
- check the free movement of the brake shoes the operation of their return springs
- replace any worn out linings
- check the condition of the driving device and lubricate the joints
- put the wheels in place and tighten the wheel bolts
Re-check the tightness of the wheel bolts after about 100 km drive (325 Nm).
- check the tyre pressure: 450 kPa (4,5 bar) on the rear axle
250 kPa (2,5 bar) on the jockey wheel
- check the free movement of the overrun brake and the parking brake
- check the safety wires
15. Check the condition of the lights and the reflectors
16. Repeat the anti-corrosion treatment using e.g. Tectyl 210R anti-corrosion agent
17. Test-run with a load of 80 kg following the loading instructions. Check the structures
after the test-run.
18. Draw up a test protocol, save your own copy and give the other copy to the customer
To Next Page
Loading...