Page 77
AIM 2 Operation Manual
If it is raining and an attempt to realign the ODU fails, you can
enable Rain Mode to account for environmental conditions
and continue troubleshooting.
Press Fn and then 4 to enable Rain Mode. Press Repeat
Test and wait for the results of the test. The Rain Mode icon
appears on the Results screen to indicate the test was run
in Rain Mode. If the test fails again, the failure may be due to
signal degradation from the rain, or there may an issue with
the LNB.
9. When you have nished reviewing EIV Plus
results on the EIV PLUS RESULTS screen, you
can press DONE to return to the HOME screen.
You also can press CHANGE LOC to perform
EIV Plus for another location.
On the EIV PLUS DETAILS screen, you can press NEXT to
view the details for another orbital slot, or press BACK to
scroll back through the details to the EIV PLUS RESULTS
screen.
You also can press NOTES to add a note about the EIV Plus.
To Next Page
Loading...
Need help?
General
