dji MATRICE 3D Series - Third-Party Cloud Platform; FAR Remote ID Compliance Information

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
111
• Make sure that the payload is installed securely to avoid risk of falling payload during ight
tasks, which will seriously aect ight safety.
• Make sure to seal the ports properly when connecting the payload to the aircraft. Use
sealants if necessary. If any of the seals fail and water leaks into the aircraft, it will seriously
aect ight safety.
Third-Party Cloud Platform
Based on Cloud API, users can tailor a customized management system for the dock or
quickly connect it to a third-party cloud platform, facilitating ecient and convenient private
conguration. Visit https://developer.dji.com/cloud-api/ for more information at cloud API.
Users can bind the dock to a third-party cloud platform using DJI Pilot 2 when conguring the
dock. Refer to Installation and Setup Manual for more information.
FAR Remote ID Compliance Information
The unmanned aircraft system is equipped with a Remote ID system that meets the
requirements of 14 CFR Part 89.
• The aircraft automatically initiates a pre-flight self-test (PFST) of the Remote ID system
before takeo and cannot take o if it does not pass the PFST
[1]
. The results of the PFST of
the Remote ID system can be viewed in a DJI ight control app such as DJI Pilot 2 or in a DJI
cloud platform such as DJI FlightHub 2.
• The aircraft monitors the Remote ID system functionality from pre-flight to shut down. If
the Remote ID system malfunctions or has a failure, an alarm will be displayed in a DJI ight
control app such as DJI Pilot 2 or in a DJI cloud platform such as DJI FlightHub 2.
• The user shall keep the DJI ight control app running in the foreground and always allow it
to obtain the location information of the remote controller when using the DJI ight control
app to y the aircraft.
• Developers who develop third-party applications based on the DJI Mobile SDK shall obtain
and display the PFST results and the failure status of the Remote ID system during operation
by calling specic APIs
[2]
.