dji MATRICE 3D Series - Connecting the Remote Controller as Controller B

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
67
Connecting the Remote Controller as Controller B
To ensure ight test safety, the remote controller can be used to take control of the aircraft
manually during on-site flight tests after connecting to the aircraft as controller B. Link the
remote controller to the aircraft as controller B following the steps below:
1. Power on the remote controller and the aircraft.
2. Run DJI Pilot 2, select Matrice 3D Series in the homepage.
3. Tap Controller A > Switch to Controller B.
4. Press and hold the power button of the aircraft for more than four seconds. The aircraft will
beep once, and its battery level LEDs blink in sequence.
5. When linking is successful, the remote controller will beep twice.
• Make sure to link the dock and the aircraft rst, and then link the remote controller
and the aircraft.