dji MATRICE 3D Series - System Assembly; Pre-Flight Checklist; On-Site Checklist

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
63
System Assembly
The dock needs to be installed by a DJI-authorized service provider with the aircraft prepared
on site at the same time, in order for the dock and the aircraft to be congured after assembly
and installation.
To ensure that the dock and aircraft are properly functioning, an on-site ight test of automatic
operation should be performed in DJI FlightHub 2 after completing the dock conguration.
Refer to the DJI Dock 2 Installation and Setup Manual for more information.
• Make sure to contact a DJI-authorized service provider for installation. There may be
potential safety hazards if the product is installed by the user. Contact DJI Support for
more information on DJI-authorized service providers.
Pre-Flight Checklist
After adding a new flight route or changing the flight route settings, it is recommended to
perform an on-site ight test to ensure normal dock operation.
On-site Checklist
• Make sure there is no foreign matter in the battery port of the aircraft.
• Make sure the battery is installed rmly, the battery buckles are clicked into place, and the
battery locking arms are rmly secured.
• Make sure the propellers are securely mounted and not damaged or deformed and that
there is no foreign matter in or on the motors or propellers.
• Make sure the lenses of the vision system, gimbal cameras, the glass of the infrared sensors,
and the auxiliary lights are clean and not blocked in any way.
• Make sure the covers of the microSD card slot, the USB-C assistant port (E-Port Lite), and the
E-Port are rmly closed.
• Make sure that the wind speed gauge rotates properly and that the rainfall gauge surface is
clear of dirt or foreign matter.
• Make sure the landing pad surface is clear of dirt or foreign matter.
• Make sure the temperature and humidity sensor inside the dock cover is not blocked in any
way.
• Make sure the aircraft is correctly placed on the landing pad and the aircraft heading is
aligned with the arrow mark. To ensure ight safety, make sure that there is no obstacle
within 5 m of the dock.
• Make sure the emergency stop button is released.
• Modify the aircraft settings using the remote controller based on actual needs. Check the
settings of the obstacle braking distance, warning distance, and gimbal camera settings in
DJI Pilot 2.