dji MATRICE 3D Series - Emergency Stop Button

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
88
©
2024 DJI All Rights Reserved.
takes control in S mode or F mode, the ight route task will be interrupted and RTH will be
triggered.
8. The remote controller can be used to modify the ight control system, the sensing system,
other aircraft settings, and the camera settings.
9. Both the rmware of the dock and the aircraft can be updated in DJI FlightHub 2, but the
remote controller can only be used to update the rmware of the remote controller.
10. Users can upload the logs of both the dock and the aircraft in DJI FlightHub 2, but can only
upload the logs of remote controller using the remote controller.
11. Remote controller B cannot be used to update the Fly Safe database, and cannot upload
unlocking license for GEO Zones.
Emergency Stop Button
The dock has one emergency stop button. In an emergency, press the emergency stop button
to stop all dock movements when operating or maintaining the dock. The status indicators blink
red and yellow alternatively after pressing the emergency stop button.
If the aircraft is powered on but the motors are not running, the aircraft cannot take o after
pressing the emergency stop button. If the emergency stop button is pressed when the aircraft
is performing a ight task, the aircraft will y to the alternate landing site after completing the
ight task.
• Pull out or rotate the button clockwise to release the emergency stop button before
performing any dock operations (e.g. dock cover control).