To Next Page

To Previous Page

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual

DJI FlightHub 2 Checklist

• Open the DJI FlightHub 2 project page, click > and check the following:

a. Make sure the dock status is Idle, and the aircraft status is in Standby or Powering O.

b. Make sure the wind speed, temperature, and rainfall are within the reasonable range,

and the dock network connection is stable.

c. Click Live to view the dock livestream. Make sure the dock cover surface is clear of

obstacles and snow or ice.

d. Click Action to check the device status. Make sure the dock RTK is calibrated and

converged, the satellite signal is strong, and that the device storage has enough free

space.

e. Make sure to enable the obstacle sensing of the aircraft and enable the beacon at night.

Make sure to set the max ight altitude, max ight distance, and alternate route altitude

based on actual ight conditions.

• Make sure the dock and aircraft rmware have been updated to the latest version in the

Devices page.

• Make sure that an alternate landing site is set.

• Check the following ight route settings:

a. Make sure that the ight route does not pass through any GEO Zones, and that the ight

route keeps a horizontal distance of at least 20 m away from the GEO Zones.

b. Check the takeo point, altitude mode, and ight altitude. When ying near a GEO Zone,

it is recommended to set the ight route altitude at least 5 m lower than the maximum

ight altitude allowed in Altitude Zone.

• When creating a task plan, make sure to set the RTH altitude at least 5 m lower than the

maximum ight altitude allowed in Altitude Zone.

• Pay attention to the ight altitude, ight speed, battery level, and other ight parameters

during the ight test.

• Divide the airspace for ight when multiple aircraft are operating simultaneously in order to

avoid collision mid-air.

• It is recommended to link the remote controller as controller B before ight tests for

safety reasons.

• To ensure flight precision, when importing flight routes to DJI FlightHub 2, make

sure the RTK signal source of the ight route is the same as the signal source used

to calibrate the dock RTK. Otherwise, the actual ight trajectory of the aircraft diers

from the preset ight route, and may even cause the aircraft to crash.

dji MATRICE 3D Series Flight Manual

Other manuals for dji MATRICE 3D Series