dji MATRICE 3D Series - Takeoff;Landing; Automatic Takeoff;Landing; Manual Takeoff;Landing

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
70
©
2024 DJI All Rights Reserved.
• If the aircraft status indicator blinks red and yellow alternately after calibration is
completed, this indicates the current location is unsuitable for ying due to the level of
magnetic interference. Choose a new location.
• A prompt will appear in DJI Pilot 2 if compass calibration is required before takeo.
The prompt will disappear after the calibration is complete.
• If the prompt appears again in DJI Pilot 2 when placing the aircraft on the ground after
calibration, try moving the aircraft to a dierent location.
Calibrating the Gimbal
Enter the camera view of DJI Pilot 2 and tap > to begin Gimbal Auto Calibration.
Takeo/Landing
Automatic Takeo/Landing
The dock cover opens after initiating a ight task, and the aircraft takes o from the dock. Once
the aircraft takes o, the dock cover will close and the aircraft will begin to perform the ight
task.
After completing the flight route, the aircraft flies above the dock, and the dock cover
automatically opens to allow the aircraft to land. After the aircraft lands, the dock cover
automatically closes.
Manual Takeo/Landing
The remote controller can be used to control the aircraft manually during on-site ight tests.
The Combination Stick Command (CSC) listed below is used to start and stop the aircraft
motors.
Takeo
Perform a Combination Stick Command (CSC) as shown below to start the motors. Once the
motors have started spinning, release both sticks simultaneously. Gently push the throttle stick
up to take o.
Take o immediately once the motors are spinning. Otherwise, the aircraft may lose balance,
drift, or even take o by itself which may risk causing damage or injury.