dji MATRICE 3D Series - Handling, Servicing and Instructions for Maintenance; Ground Handling; Installation, Removal, and Storage; Installation and Removal

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
91
Handling, Servicing and Instructions for
Maintenance
Ground Handling
Refer to the DJI Dock 2 Maintenance Manual for more information.
Installation, Removal, and Storage
Installation and Removal
The dock must be installed and set up by an authorized service provider for installation.
Unauthorized installation and set up may lead to safety risks. Contact DJI Support for more
information on DJI-authorized service providers.
Make sure to remove the power cable connector, Ethernet cable connector, and earth wire from
the dock before storage. The landing pad, external circulating fan, and external circulating vents
can be removed from the dock for maintenance. Refer to the DJI Dock 2 Maintenance Manual
for more information.
Follow the steps to remove or install the propellers for the aircraft. Make sure to remove the
battery from the aircraft before installation and removal.
Propellers
Removing the Propellers
1. Power o the aircraft and remove the battery.
2. Remove the propeller blade screws using a 2.0mm hex key.
3. Remove the propeller adapter and the rubber washers.
Installing the Propellers
There are two types of propellers, which are designed to spin in dierent directions. Marks are
used to indicate which propellers should be attached to which motors. Make sure to match the
propellers and motors by following the instructions below:
1. Match the marks on the motors and propellers, and install the propellers to the motors with
the corresponding marks.
2. Use a 2.0mm hex key to replace the propellers for the DJI Matrice 3D Series aircraft. Tighten
the screws and make sure that the screw torque is greater than 5 kgf.cm, and that the
washers are at and not twisted.
3. Use the screw glue (recommended model: 243) on the screws when replacing the propellers.