dji NEO - Preparing the Remote Controller

2
1
2. All Intelligent Flight Batteries are in hibernation mode before shipment to ensure
safety. Activate the batteries by connecting a USB charger to the USB-C port on DJI
Neo. The battery is activated when it begins charging.
≥10 W
(5 V, 2 A)
• It is recommended to attach the gimbal protector to protect the gimbal when DJI
Neo is not in use.
• The maximum charging power supported for the USB-C port on DJI Neo is 15W.
• Make sure to remove the gimbal protector before powering on DJI Neo.
Otherwise, it may aect the system performing self-diagnostics.
Preparing the Remote Controller
1. Remove the control sticks from the storage slots and mount them on the remote
controller.
2. Pull out the mobile device holder. Choose the appropriate remote controller cable
based on the port type of your mobile device (the cable with a USB-C connector is
connected by default). Place your mobile device in the holder, then connect the end
DJI Neo User Manual
10 © 2024 DJI All Rights Reserved.