3.3 RC Control
Auto Takeo
1. Launch DJI Fly and enter the camera view.
2. Complete all steps in the pre-ight checklist.
3. Tap . If conditions are safe for takeo, press and hold the button to conrm.
4. The aircraft will take o and hover approximately 1.2 m (3.9 ft) above the ground.
Auto Landing
1. If conditions are safe to land, tap , then tap and hold to conrm.
2. Auto landing can be canceled by tapping
.
3. If the Downward Vision System is working normally, Landing Protection will be
enabled.
4. Motors will stop automatically after landing.
• Choose an appropriate place for landing.
Starting/Stopping the Motors
Starting the Motors
Perform one of the Combination Stick Commands (CSC) as shown below to start the
motors. Once the motors have started spinning, release both sticks simultaneously.
Stopping the Motors
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold until the
motors stop.
DJI Neo User Manual
© 2024 DJI All Rights Reserved. 35
To Next Page
Loading...
