dji NEO - Takeoff;Landing Procedures

Remote Controller
(Mode 2)
Aircraft Operation
Yaw Stick
• Push the stick left to rotate the aircraft
counterclockwise and right to rotate
the aircraft clockwise.
• The more the stick is pushed away
from the center, the faster the aircraft
rotates.
Pitch Stick
• Push the stick up to y forward and
down to y backward.
• The more the stick is pushed away
from the center, the faster the aircraft
moves.
Roll Stick
• Push the stick left to y left and right to
y right.
• The more the stick is pushed away
from the center, the faster the aircraft
moves.
Takeo/Landing Procedures
• DO NOT operate the aircraft with the remote controller or mobile device to
monitor ight when the lighting is too bright or too dark. You are responsible for
the correct adjustment of display brightness and amount of direct sunlight on
the screen, as to avoid diculty in viewing the screen clearly.
1. The pre-ight checklist is designed to help the user y safely. Go through the full
pre-ight checklist before each ight.
2. Place the aircraft on an open, at area with the rear of the aircraft facing towards you.
3. Power on the remote controller and the aircraft.
4. Launch DJI Fly and enter the camera view.
5. Tap
> Safety, and then set an appropriate Auto RTH Altitude and Max Altitude.
6. Wait for the system self-diagnostics to complete. If DJI Fly does not show any irregular
warning, you can start the motors.
DJI Neo User Manual
38 © 2024 DJI All Rights Reserved.