dji NEO - Notice

3. Reinstall the propeller guards after installing the propellers.
Notice
• DO NOT install or remove the propeller guard by force to avoid damage.
• Make sure to only use the screwdriver in the box of DJI Neo for installing and
removing propellers. Using other screwdrivers may damage the screws.
• DO NOT use the screwdriver to disassemble DJI Neo.
• Make sure to keep the screws vertical while tightening them. The screws
should not be at a tilted angle to the installation surface. After installation,
check whether the screws are ush and rotate the propellers to check for any
abnormal resistance.
• The propeller blades are sharp. Handle with care to avoid personal injury or
propeller deformation.
• Make sure that the propellers and motors are installed securely before each
ight. Make sure the screws on the propellers are tightened after every 15 hours
of ying time (approx. 60 ights).
• If a propeller is broken, remove the propeller and screws on the corresponding
motor and discard them.
• Only use ocial DJI propellers. DO NOT mix propeller types.
• Propellers are consumable components. Purchase additional propellers if
necessary.
• Make sure that all propellers are in good condition and clean (without any
foreign matter in or on them) before each ight. DO NOT use aged, chipped,
or broken propellers. Clean the propellers with a soft, dry cloth if there is any
foreign matter attached.
• To avoid injury, stay away from rotating propellers or motors.
• To avoid damaging the propellers, pack the DJI Neo correctly for transportation
or storage. DO NOT squeeze or bend the propellers. If the propellers are
damaged, the ight performance may be aected.
DJI Neo User Manual
© 2024 DJI All Rights Reserved. 59