Blinking Pattern Battery Level
88-100%
76-87%
63-75%
51-62%
38-50%
26-37%
13-25%
0-12%
Powering On/O
Press, then press and hold the power button on DJI Neo to power it on or o. The battery
level LEDs display the battery level when is powered on. The battery level LEDs turn o
when DJI Neo is powered o.
If the two LEDs shown in the picture below blink simultaneously, it indicates the battery
is malfunctioning. Remove the battery from the device, insert the battery again and make
sure that it is securely mounted.
Updating the Firmware
If an additional battery needs to be updated, insert it into DJI Neo and power it on. A
prompt will appear in DJI Fly to update the battery rmware. Make sure to update the
battery rmware before takeo. The table below shows battery information during the
update process and corresponding LED blinking patterns.
Blinking Pattern Information
Updating battery rmware
Firmware update failed
If the update fails, reinsert the battery into DJI Neo and power on the device, and
retry the rmware update using DJI Assistant 2 (Consumer Drones Series). Refer to
the Firmware Update section in the Appendix for more information.
DJI Neo User Manual
© 2024 DJI All Rights Reserved. 63
To Next Page
Loading...
