Model WQC-30 7.9 Special dissolved oxygen functions (optional)
-
153
-
(2) Changing the dissolved oxygen mode
You can switch between the dissolved oxygen (mg/L) mode and the saturation rate (%) mode.
Steps for switching to dissolved oxygen mode
Operation Screen example
①
Go to [Dissolved Oxygen Measurement Screen]
…
Press
or on the control panel for several times in
the [Measurement Screen] of [Measurement Screen] (with
turned off).
②
Go to [Menu Screen]
…
Press
on the control
pane of the [Measurement Screen] in “Measurement State”
(with
turned off) .
③
Changing
to flash
…
If any icons except
are turned on, press or
for several times until starts
flashing.
[Menu Screen]
③
Go to [Setting Mode Screen]
…
Press
for several times until “Unit” is shown
in the data number indication area.
④
Select mode
…
Press
or to switch between
mg/L and % indication symbol.
• Setting range: mg/L
…
Dissolved oxygen mode (default)
%
…
Saturation mode
⑥
Reverting
…
Make sure that the indication icon you wish to
change is flashing, and press
on the
control panel.
• Press
or on the control panel to
return to [Menu Screen].
[Mode Setting Screen]
To Next Page
Loading...
Need help?
General