DKK-TOA WQC-30 User Manual

Model WQC-30 7.7 Special electrical conductivity functions
- 150 -
(3) Changing between old and new units
You can switch the indication in the old unit of electrical conductivity (S/cm) to new SI unit (S/m).
Steps for changing old unit to new
Operation Screen example
①
Go to [Electrical Conductivity Screen]
…
Press
or for several times on the control panel in the
[Measurement Screen] in “Measurement State”
( with turned off).
②
Go to [Menu Screen]
…
Press
on the control
pane of the [Measurement Screen] in “Measurement State”
(with
turned off) .
③
Changing
to flash
…
If any icons except
are flashing, press or on the
control panel for several times until
starts flashing.
Menu Screen
④
Go to [Setting Old and New Unit Screen]
…
Press
for several times until “Unit” is shown in the
data number indication area.
[Setting Old Unit Screen]
⑤
Select old and new unit
…
Press
or on the
control panel select old or new unit.
• Setting Range: S/m
…
SI unit (default)
S/cm
…
old unit
⑥
Reverting
…
Check the set values and press
on the control panel.
• Press
to return to [Menu Screen].
Relationship between unit and measurement range
SI unit (new) Old unit
0.0 to 200.0mS/m 0.000 to 2.000mS/cm
0.000 to 2.000S/m 0.00 to 20.00mS/cm
0.00 to 20.00S/m 0.0 to 200.0mS/cm
[Setting SI Unit Screen]

DKK-TOA WQC-30 Specifications

General

Brand	DKK-TOA
Model	WQC-30
Category	Measuring Instruments
Language	English