10 XR150/XR350/XR550 User Guide Introduction
Special Keypad Displays
As you use your system, you occasionally see a keypad display
that asks you to enter a code or that describes a condition on the
system. Below are some examples of the keypad displays:
ALARM
A 24-hour zone (for example re or panic) or an armed burglary
zone has been tripped. Your system may sound bells or sirens.
TRBL (TROUBLE)
There is a problem with a protection device or system component.
This display is accompanied by a description of the problem.
ALARM NOT SENT
The alarm signal was aborted and was not sent to the central
station because a valid user code was entered to disarm the
system before the alarm signal was sent to the central station.
Also, your system may be pre-programmed at installation to send
an Abort signal to the Central Station that an alarm occurred but
was not sent because the user entered a code before the delay
time expired.
ALARM CANCELLED
An Alarm signal just sent to the central station was cancelled
because a valid user code was entered to disarm the system after
the alarm was sent. Also, an Alarm Cancel signal is sent to the
Central Station.
ALARM VERIFIED
Avalidburglaralarmhasoccurredandhasbeenmanuallyveried
by the user. The alarm system also transmits a VERIFY message to
the Central Station.
ENTER CODE OR PRESENT CARD
The system requires you to enter your user code or present your
user card/proximity credential to a keypad or card reader. User
codes or reads can be required for turning your system on (arming),
turning your system off (disarming), and many other functions.
As you enter your user code, the keypad display shows an asterisk
(*) in place of each digit pressed. This keeps others from seeing
your user code on the display as it is entered.
TRY AGAIN OR INVALID CODE/CARD/PIN
The user code, card read, or PIN you have used is not recognized
bythesystemorisnotauthorizedintheirproleforthatfunction.
Check the User Code or PIN, or present the card to the reader
again.
INVALID PROFILE
All user codes have a prole that allow the user to only access
certain functions. When users attempt functions outside their
authority, the INVALID PROFILE message displays.
INVALID AREA
A user has attempted a door access for an area they are not
assigned.
INVALID TIME
Ausercodeassignedto a specic schedule isenteredoutsideof
the valid schedule. See Schedules and User Codes.
ARMED AREA
A user has attempted a door access to an armed area to which they
do not have arming and disarming authority.
FAILED TO EXIT (ANTI-PASSBACK)
Anti-passback requires users to properly exit (egress) an area they
have previously accessed. If they fail to exit through the proper
To Next Page
Loading...
Need help?
General
