XR150/XR350/XR550 User Guide 25User Menu
DISPLAY EVENTS Allows you to view or print the last 10,000
door accesses or 2,000 system events that
occurred on your system.
SERVICE REQUEST Allows you to send a message to the Central
Station requesting service on the alarm
system.
FIRE DRILL Allowsyoutotestthesystemrebells.
Alarm Silence
Silences the alarm bells or sirens during an alarm.
Alarm Silence allows you to turn off the alarm bells and sirens
connected to your system during an alarm. Using Alarm Silence
does NOT stop an alarm report from being sent to the central
station and does not reset any alarmed devices. Use the Sensor
Reset function to reset devices such as smoke detectors that have
latched in alarm.
Note:Thekeypadtonesilencesassoonastherstusercodedigit
key is pressed. You can silence the alarm by entering your
user code or by presenting your card to a reader during the
Status List display. If using a card, areas assigned to your
code are disarmed and door access occurs.
Using the Alarm Silence Function
1. Access the User Menu.
2. The keypad displays ALARM SILENCE?.
3. Press any Select key to silence the bells and exit the User
Menu.
Sensor Reset
Resets smoke or glassbreak detectors. Also clears Fire/Supervisory
alarm, trouble displays or low battery displays on systems using
wireless sensors.
Sensor Reset is used to reset smoke and glassbreak detectors after
they have tripped. Once these detectors trip, they must be reset
before they can detect any additional alarm conditions. When you
select Sensor Reset, power to the detectors is temporarily removed
by the system allowing them to reset.
Make sure all smoke is cleared from around the area of the smoke
detectors before performing a Sensor Reset to prevent the alarm
from occurring again.
Sensor (Fire) Reset Shortcut Key
All Systems — Press 2 for 2 seconds, then enter your user code if
required, to reset the system.
Resetting the Sensors
1. Access the User Menu.
2. Press COMMAND until SENSOR RESET? displays.
3. The keypad displays SENSORS OFF followed by SENSORS ON.
4. The keypad automatically exits the User Menu.
Lockdown
Your system may be programmed at installation for an access
control door to be a Public Door. Enabling Lockdown locks all
Public Doors from the keypad in an emergency situation.
Using Lockdown
1. Access the User Menu.
2. Press COMMAND until LOCKDOWN? displays.
3. Press any Select key. The door access relay is activated and
all Public Doors are locked.
4. Press COMMAND to return to the Status List display.
To Next Page
Loading...
Need help?
General
