XR150/XR350/XR550 User Guide 27User Menu
Under certain conditions, some outputs cannot be turned
on. If you select a restricted output, the keypad displays
CANNOT TURN ON.
Note: Z-Wave Setup will not be available to the user if Outputs On
OffisnotenabledfortheUserinUserProles.
Turning the Outputs ON and OFF
1. Access the User Menu.
2. Press COMMAND until OUTPUTS ON/OFF? displays.
3. Press any Select key.
4. Enter the output number you want to turn ON or OFF. The
output number displays.
5. With the output number displayed, select ON or OFF. The
output then turns ON or OFF depending on your selection,
and remains in that state until you change it. The keypad
displaystherst12charactersoftheoutput ordoorname
followed by either ON or OFF for four seconds to provide
visualvericationoftheaction.PresstheCOMMAND key to
end the four second display.
6. The system automatically returns to the output or door
option and a new output can be selected to turn ON or OFF.
Refer back to step 4.
7. Press the Back Arrow key to exit the User Menu.
Browser Feature
If you are unsure of the output number, refer to
Appendix B at the back of this guide for a diagram showing you
how to use the built-in Outputs ON/OFF browser.
Favorite
Allows you to activate a Z-Wave Favorite. Z-Wave devices can
be grouped together to create Favorites. Favorites can only be
activated, or turned on. A separate Favorite must be created to
change the conditions set by the rst Favorite. For a complete
description on how to add a Favorite to activate. See Adding a
FAVORITE in Z-Wave Setup.
1. When FAVORITES? displays, press any Select key. The keypad
displays FAVORITE: -.
2. Enter a Favorite number from 1-20. Pressing COMMAND
activates the Favorite.