20 XR150/XR350/XR550 User Guide Arming and Disarming
Disarming During an Alarm
1. While the alarm bell or siren sounds, enter your user code to
silence the alarm. The keypad tone silences as soon as the
rstkeyispressed.
For a burglary alarm, the keypad displays
IS THIS A FALSE ALARM? NO YES or CANCEL VERIFY.
This allows you to investigate the alarm prior to disarming
the system. This display remains on the keypad until a
selection is made, the Back Arrow is pressed, or the internal
system bell cutoff timer expires.
2. If a valid alarm has not occurred, select YES or CANCEL to
disarm the system and cancel the alarm.
The keypad next displaysALL SYSTEM OFF to conrm the
system is disarmed.
OR
If the alarm is valid, select NO or VERIFY to send a verify
message to the Central Station. The system will remain
armed.
Home/Sleep/Away and Home/Sleep/Away with
Guest System Arming
Area Assignment: Your security system is divided into two or three
separate areas. Motion detectors, inside doors, and other interior
devices are assigned to an Interior and Bedroom areas while
windows and exterior doors are assigned to a Perimeter area.
Arming the system: When arming a Home/Sleep/Away or a Home/
Sleep/Away with Guest system, the keypad displays HOME AWAY
or HOME SLEEP AWAY. If you select AWAY, you arm all areas of the
system. You will want to arm all areas when leaving with nobody
staying inside. Selecting HOME arms only the Perimeter of the
system. Perimeter arming is when you are staying inside but want
the comfort of knowing the exterior doors and windows are armed.
Perimeter arming allows you to move freely about inside without
setting off any interior alarms. Selecting SLEEP arms the Perimeter
and Interior devices but leaves devices near bedrooms or other
nighttime areas off.
System Ready/System Not Ready Keypad
Displays
When all zones in the system are in a normal condition and can
be armed without bypassing, the keypad displays SYSTEM READY.
If there are one or more zones that are not in a normal condition,
the keypad displays SYSTEM NOT READY. Pressing any top row
Select key during this display shows the zone number and name
allowing you to investigate the problem.
Home/Sleep/Away and Home/Sleep/Away
with Guest Shortcut Key Arming
Arm Home — Press 3 for 2 seconds to arm the perimeter.
Arm Sleep — Press 7 for 2 seconds to arm the perimeter and
interior areas and leave the bedroom area off.
Arm Away — Press 1 for 2 seconds.
Arming a Home/Sleep/Away or a Home/Sleep/
Away with Guest System
1. Enter your 4-digit user code. The keypad displays
HOME SLEEP AWAY.
2. Select HOME to arm the Perimeter only.
3. Select SLEEP to arm the Perimeter and Interior.
4. Select AWAY to arm the Perimeter, Interior, and Bedroom.
5. The system displays any Bypassed zones or faulted 24-hour
or Priority zones. A faulted Priority zone cannot be armed.
6.
At this point you can force arm or bypass any faulted zones.
A zone that is force armed will be restored into the system if
it later returns to normal. A zone that is bypassed will remain
bypassed until the system is disarmed. See 6a through 6d.
To Next Page
Loading...
Need help?
General
