XR150/XR350/XR550 User Guide 21Arming and Disarming
6a. If a problem exists on a zone, the zone name and problem
is shown followed by OKAY BYPASS STOP.
6b. Select OKAY to force arm the zone(s) before arming.
6c. Select BYPASS to bypass the zone(s) before arming.
6d. Select STOP to stop the system from arming. Correct the
zone problem(s) and return to step 1.
7. A Home/Sleep/Away system keypad displays HOME SYSTEM
ON if you selected HOME, SLEEP SYSTEM ON if you selected
SLEEP, and ALL SYSTEM ON if you selected AWAY.
A Home/Sleep/Away with Guest system keypad displays
HOME GUEST 1 (or 2) ON if you selected HOME, SLEEP GUEST
1 (or 2) ON if you selected SLEEP, and ALL GUEST 1 (or 2) ON
if you selected AWAY.
8. If arming the Perimeter, the keypad next displays EXIT: ##
INSTNT and begins to count down the number of seconds
remaining for you to exit. When the delay expires, the exit
zones are armed.
9. You can select INSTNT while EXIT: ## INSTNT is displayed to
immediately arm all exit zones and make them instant. The
keypad displays INSTANT.
Home/Sleep/Away and Home/Sleep/Away with
Guest System Disarming
Disarming: While the system is armed, you can only enter the
premises through an entry/exit delay door without causing an
alarm. After opening the door, the keypad sounds a prewarn tone
to remind you to disarm the system. You must disarm the system
before the prewarn tone expires or an alarm on the door zone will
occur.
During the prewarn tone, the keypad displays ENTER CODE:. Enter
your user code to disarm the system.
Schedules: If you have programmed schedules for your system and
a user code is entered outside of a schedule, the keypad displays
INVALID TIME. This lets the user know that they are disarming
outside of their authorized time.
Alarm Display: After disarming, the keypad dis plays any zones
that tripped or any transmission problems that occurred dur ing the
armed period. All burglary zones are then dis armed and any by-
passed zones are automatically reset.
Disarmed Message: The keypad displays ALL SYSTEM OFF after the
system disarms.
Central Sta tion Report: A report of the system disarming can be
transmitted to the central sta tion. This is optional and can be
programmed for you at any time.
Disarming a Home/Sleep/Away or a Home/
Sleep/Away with Guest System
1. During the entry delay time, the keypad displays
ENTER CODE:. Enter your 4-digit user code.
2. The keypad then displays any alarms or communication
problems that occurred during the armed period.
3. The keypad next displays ALL SYSTEM OFF to conrm the
system is disarmed.
Disarming During an Alarm
1. While the alarm bell or siren sounds, enter your user code to
silence the alarm. The keypad tone silences as soon as the
rstkeyispressed.
For a burglary alarm, the keypad displays
IS THIS A FALSE ALARM? NO YES or CANCEL VERIFY.
This allows you to investigate the alarm prior to disarming
the system. This display remains on the keypad until a
selection is made, the Back Arrow is pressed, or the internal
system bell cutoff timer expires.
To Next Page
Loading...
Need help?
General
