DMP Electronics XR150 User Manual

36 XR150/XR350/XR550 User Guide User Menu
Using the Panic Zone Test
(XR550N/XR550E only)
1. Access the User Menu.
2. Press COMMAND until SYSTEM TEST? displays.
3. Press any Select key. The keypad displays SYSTEM ZONES.
Select ZONES.
4. The keypad displays BURG PANICS. Select PANICS.
5. The Panic Zone Test begins automatically and the keypad
displays TRIPS: END.
During the Panic Zone Test, trip each panic zone (or button)
by pressing and holding the panic for 1 to 2 seconds.
Note:
You do NOT have to hold the panic for 2 seconds in normal
mode. The Panic Zone Test takes additional time to display
when the system is in test mode.
Each time you trip a panic zone, the display number
increments and the keypad buzzer sounds for two seconds.
The number of panic zones tripped constantly displays until
the test ends or no panic zone activity has occurred for 20
minutes.
6. Select END to stop the Panic Zone Test.
7. PANIC TEST OKAY displays when the Panic Zone Test is
completed and all zones tested OK.
8. When the Panic Zone Test ends and a zone failed (did not
trip) during the test, the keypad displays the zone name
and number and the buzzer sounds for one second. Press the
COMMAND key to display the next failed zone.
Note: If testing a key fob, a message will not display if it fails, only
thevericationmessageisdisplayed.
Using the Burglary Zone Test
(XR550N/XR550E only)
1. With the system disarmed, access the User Menu.
2. Press COMMAND until SYSTEM TEST? displays.
3. Press any Select key. The keypad displays:
SYSTEM TEST? SYSTEM ZONES. Select ZONES.
4. The keypad displays SYSTEM TEST? BURG PANICS.
Select BURG.
5. The Burg Zone Test begins automatically and the keypad
displays TRIPS: 000 END.
During the Burg Zone Test, trip each burg zone.
Note: Each time you trip a burg zone, the display number
increments and the keypad buzzer sounds for two seconds.
The number of burg zones tripped displays until the test
ends or no burg zone activity has occurred for 20 minutes.
6. Select END to stop the Burg Zone Test.
7. BURG TEST OKAY displays when the Burg Zone Test is
completed and all zones tested OK.
8. When the Burg Zone Test ends and a zone failed (did not
trip) during the test, the keypad displays the zone name
and number and the buzzer sounds for one second. Press the
COMMAND key to display the next failed zone.

DMP Electronics XR150 Specifications

General

Brand	DMP Electronics
Model	XR150
Category	Control Panel
Language	English