DMP Electronics XTLC - Supervisory;Trouble Reports

Digital Monitoring Products XTL/XTLC Programming Guide
8
COMMUNICATION
3.22
SPV/TRBL NO YES
Supervisory/Trouble Reports
YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close, and
Fault reports to be sent to this receiver. Default is NO.
3.23
O/C USER NO YES
Opening/Closing and User Reports
YES enables Opening/Closing, Code Changes, and Bypass reports by user to be sent
to this receiver. Default is NO.
3.24
TEST RPT NO YES
Test Report
YES enables the Recall Test report to be sent to this receiver. Default is NO.
3.25
FIRST IP ADDR
000.000.000.000
First IP Address
Enter the rst (primary) IP address where the panel sends cell messages. Enter all
12 digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
The message is sent using rst GPRS APN and the rst IP Address. If no
acknowledgment is received, rst GPRS APN and the second IP address are used,
followed, if needed, by second GPRS APN and rst and second IP addresses,
respectively.
3.26
FIRST IP PORT
2001
First IP Port
Enter the rst IP port number to be used in conjunction with the First IP Address.
The IP port identies the port used to communicate messages to and from the
panel. The default IP Port setting is 2001.
3.27
SECOND IP ADDR
000.000.000.000
Second IP Address
Enter the second IP address where the panel sends cell messages. Enter all 12
digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
3.28
SECOND IP PORT
2001
Second IP Port
Enter the second IP port number to be used in conjunction with the second IP
Address. The IP port identies the port used to communicate messages to and from
the panel. The default IP Port setting is 2001.