DMP Electronics XTLC - Device Setup; Wireless Device Configuration; Wireless Supervision

XTL/XTLC Programming Guide Digital Monitoring Products
11
DEVICE SETUP
Device Setup
5.1
DEVICE SETUP
Device Setup
This section allows you to dene the panel wireless keypad conguration. You can
install and address up to four wireless keypads.
5.2
DEVICE NO:-
Device Number
Enter the device number of the wireless keypad you are programming. The valid
range is 2-5.
Note: Address one is reserved for the XTL/XTLC programming keypad attached
during programming. After you program each option for the rst keypad, repeat
these programming steps for each additional keypad.
5.3 Device Name
This section allows you to dene a 16 character alphanumeric name for the device
number. If no name is entered, *UNUSED* is displayed.
To remove a keypad from the system, delete the device name by pressing any Select
key, then press the COMMAND key. The device name is now displayed as * UNUSED *.
5.4 Wireless
Select YES to use a wireless keypad. Default is YES.
5.5
SERIAL#: XXXXXXXX
Serial Number
Enter the eight-digit serial number found on the wireless keypad.
5.6
SUPRVSN TIME: 240
Supervision Time
Press any top row key to select the supervision time required for the device. Press
COMMAND to accept the default time. Default is 240 minutes.
SELECT MINUTES:
0 60 240
Press the Select key under the required number of minutes. The device must check
in at least once during this time or a missing condition is indicated for that device.
Zero (0) indicates an unsupervised wireless keypad.
Note: When the panel is reset, panel is powered down and powered up, or
programming is complete, the supervision timer restarts for all wireless keypads.
* UNUSED *
WIRELESS? NO YES