DMP Electronics XTLC - Output Options; Output Functionality; Output Behavior by Event

XTL/XTLC Programming Guide Digital Monitoring Products
19
OUTPUT OPTIONS
Output Options
10.1
OUTPUT OPTIONS
Output Options
This section allows you to program output options for the 1116 and 1117 wireless
outputs.
Select from the following output numbers:
• 31 to 34
• 41 to 44
• F01 to F20 (To Activate Z-Wave Favorites)
10.2
COM FAIL OUT: 0
Communication Failure Output
This output/Favorite turns on when the panel fails to communicate with the
receiver after eight successive attempts. Enter 0 (zero) to disable this output.
Note: To turn off the Communication Failure Output, disarm the panel or turn the
output off using the User Menu Outputs On/Off function.
10.3
FIRE ALR OUT: 0
Fire Alarm Output
This output/Favorite turns on any time a re type zone is placed in alarm. The
output turns off using the Sensor Reset option when no additional re type zones
are in alarm. Enter 0 (zero) to disable this output.
10.4
PANC ALM OUT: 0
Panic Alarm Output
This output/Favorite turns on any time a Panic Zone (PN) is placed in alarm. The
output turns off using the Sensor Reset option once all Panic Zones are restored.
Enter 0 (zero) to disable this output.
If a wireless ouput is programmed, the panel sends the Panic Test Cadence or the
Panic Alarm Cadence to the output when a Panic Test is performed or a Panic Zone
is placed in alarm.
10.5
ENTRY OUT: 0
Entry Output
This output/Favorite turns on at the start of the entry delay time. The output turns
off when the area disarms or the entry delay time expires. Enter 0 (zero) to disable.
10.6
BEGIN EXIT: 0
Begin Exit Output
This output/Favorite turns on any time an exit delay time starts. The output turns
off when the system arms or when the arming has been stopped. Enter 0 (zero) to
disable.
10.7
END EXIT: 0
End Exit Output
This output/Favorite turns on any time an exit delay time ends. The output turns off
when the system disarms. Enter 0 (zero) to disable.
10.8
ARMED OUT: 0
Armed Output
This output/Favorite turns on any time an area of the system is armed. The output
turns off when the system completely disarms. Enter 0 (zero) to disable this output.
Favorites:
For a Home/Away system:
• When the system is armed AWAY, the programmed Favorite activates.
• When the system is armed SLEEP, the programmed Favorite plus 1 is activated.
For example, If the Armed Output is F05, F06 activates when Sleep is armed.
• When the system is armed HOME, the programmed Favorite plus 2 is activated.
For example, If the Armed Output is F05, F07 activates when Home is armed.
For an All/Perimeter system:
• When the system is armed ALL, the programmed Favorite activates.
• When the system is armed PERIMETER, the programmed Favorite plus 1 is
activated.
For example, If the Armed Output is F05, F06 activates when Perimeter is armed.
For an Area system:
• When any area of the system is armed, the programmed Favorite activates.